Specifications

DGS-3024 Layer 2 Switch CLI Reference Manual
config stp mst_ports
range of 1-2000000 will set the quickest route when a loop occurs. A
lower internalCost represents a quicker transmission.
priority <value 0-240> - Enter a value between 0 and 240 to set the priority
for the port interface. A higher priority will designate the interface to
forward packets first. A lower number denotes a higher priority.
Restrictions Only administrator-level users can issue this command.
Example usage:
To designate ports 1 through 5, with instance ID 2, to have an auto internalCost and a priority of 16:
DGS-3024:4#config stp mst_config_id ports 1-5 instance_id 2
internalCost auto priority 16
Command : config stp mst_config_id ports 1-5 instance_id 2
internalCost auto priority 16
Success.
DGS-3024:4#
show stp
Purpose Used to display the Switch’s current STP configuration.
Syntax
show stp
Description This command displays the Switch’s current STP configuration.
Parameters None.
Restrictions None.
Example usage:
To display the status of STP on the Switch:
Status 1: STP enabled with STP compatible version
DGS-3024:4#show stp
Command: show stp
STP Status : Enabled
STP Version : STP Compatible
Max Age : 20
Hello Time : 2
Forward Delay : 15
Max Hops : 20
TX Hold Count : 3
Forwarding BPDU : Enabled
Loopback Protection : Enabled
LBD Recover Time : 60
DGS-3024:4#
Status 2 : STP enabled for RSTP
72