Specifications

DGS-3024 Layer 2 Switch CLI Reference Manual

DGS-3024:4#create syslog host 1 ipaddress 10.53.13.94 severity all facility local0

Command: create syslog host 1 ipaddress 10.53.13.94 severity all facility local0

Success.

DGS-3024:4#

config syslog host

Purpose Used to configure the syslog protocol to send system log data to a

remote host.

Syntax

config syslog host {host [all <index 1-4>]} {severity [informational

local5 | local6 | local7] | udp_port <udp_port_number> | ipaddress

<ipaddr> | state [enable | disable]}

Description

The config syslog host command is used to configure the syslog

protocol to send system log information to a remote host.

Parameters

all − Specifies that the command will be applied to all hosts.

<index 1-4> − Specifies that the command will be applied to an index

of hosts. There are four available indexes, numbered 1 through 4.

severity − Severity level indicator. These are described in the

following:

Bold font indicates that the corresponding severity level is currently

supported on the Switch.

Numerical Severity

Code

0 Emergency: system is unusable

1 Alert: action must be taken immediately

2 Critical: critical conditions

3 Error: error conditions

4 Warning: warning conditions

5 Notice: normal but significant condition

6 Informational: informational messages

7 Debug: debug-level messages

informational − Specifies that informational messages will be sent to

the remote host. This corresponds to number 6 from the list above.

warning − Specifies that warning messages will be sent to the remote

host. This corresponds to number 4 from the list above.

Parameters

all − Specifies that all of the currently supported syslog messages that

are generated by the Switch will be sent to the remote host.

facility − Some of the operating system daemons and processes have

been assigned Facility values. Processes and daemons that have not

been explicitly assigned a Facility may use any of the "local use"

facilities or they may use the "user-level" Facility. Those Facilities that

have been designated are shown in the following: Bold font indicates

the facility values the Switch currently supports.

Numerical Facility