Specifications

DGS-3024 Layer 2 Switch CLI Reference Manual
config ports
specified ports.
learning [enable | disable] − Enables or disables the MAC address
learning on the specified range of ports.
state [enable | disable] − Enables or disables the specified range of ports.
description <desc 32> - Enter an alphanumeric string of no more than 32
characters to describe a selected port interface.
clear_description - Enter this command to clear the port description of the
selected port(s).
Restrictions Only administrator-level users can issue this command.
Example usage:
To configure the speed of ports 1-3 to be 10 Mbps, full duplex, learning and state enabled:
DGS-3024:4#config ports 1-3 speed 10_full learning enable state enable
Command: config ports 1-3 speed 10_full learning enable state enable
Success.
DGS-3024:4#
show ports
Purpose Used to display the current configuration of a range of ports.
Syntax
show ports {<portlist>} {[description]}
Description This command is used to display the current configuration of a range
of ports.
Parameters
<portlist> − Specifies a port or range of ports to be displayed.
description – Adding this parameter to the show ports command
indicates that a previously entered port description will be included in
the display.
Restrictions None.
Example usage:
To display the configuration of ports 1-5 on the Switch:
DGS-3024:4#show ports 1-5
Command: show ports 1-5
Port Port Settings Connection Address
State Speed/Duplex/FlowCtrl Speed/Duplex/FlowCtrl Learning
--- -------- --------------------- --------------------- --------
1 Enabled Auto/Enabled Link Down Enabled
2 Enabled Auto/Enabled Link Down Enabled
3 Enabled Auto/Enabled 1000M/Full?None Enabled
4 Enabled Auto/Enabled Link Down Enabled
5 Enabled Auto/Enabled Link Down Enabled
CTRL+C ESC q Quit SPACE n Next Page p Previous Page r Refresh
22