Specifications

DGS-3024 Layer 2 Switch CLI Reference Manual
Example usage:
To configure a static ARP entry for the IP address 10.48.74.12 and MAC address 00:50:BA:00:07:36:
DGS-3024:4#config arpentry 10.48.74.12 00-50-BA-00-07-36
Command: config arpentry 10.48.74.12 00-50-BA-00-07-36
Success.
DGS-3024:4#
delete arpentry
Purpose Used to delete a static entry into the ARP table.
Syntax
delete arpentry {<ipaddr> | all}
Description This command is used to delete a static ARP entry, made using the
create arpentry command above, by specifying either the IP address
of the entry or all. Specifying all clears the Switch’s ARP table.
Parameters
<ipaddr> − The IP address of the end node or station.
all − Deletes all ARP entries.
Restrictions Only administrator-level users can issue this command.
Example usage:
To delete an entry of IP address 10.48.74.121 from the ARP table:
DGS-3024:4#delete arpentry 10.48.74.121
Command: delete arpentry 10.48.74.121
Success.
DGS-3024:4#
config arp_aging time
Purpose Used to configure the age-out timer for ARP table entries on the Switch.
Syntax
config arp_aging time <value 0-65535 >
Description This command sets the maximum amount of time in minutes, which an
ARP entry can remain in the Switch’s ARP table, without being
accessed before it is dropped from the table.
Parameters
time <value 0-65535> − The ARP age-out time, in minutes. The value
may be set in the range of 0-65535 minutes with a default setting of 20
minutes.
Restrictions Only administrator-level users can issue this command.
Example usage:
To configure ARP aging time:
DGS-3024:4#config arp_aging time 30
Command: config arp_aging time 30
Success.
DGS-3024:4#
171