Specifications

DGS-3024 Layer 2 Switch CLI Reference Manual
23
TIME AND SNTP COMMANDS
The Simple Network Time Protocol (SNTP) (an adaptation of the Network Time Protocol (NTP)) commands in the Command
Line Interface (CLI) are listed (along with the appropriate parameters) in the following table.
Command Parameters
config sntp {primary <ipaddr> | secondary <ipaddr> | poll-interval <int 30-99999>}
enable sntp
disable sntp
config time <date ddmmmyyyy> <time hh:mm:ss >
config time-zone {operator [+ | -] | hour <gmt_hour 0-13> | min<minute 0-59>}
config dst
[disable | repeating {s_week <start_week 1-4,last> | s_day <start_day
sun-sat>| s_mth <start_mth 1-12> | s_time <start_time hh:mm> | e_week
<end_week 1-4,last> | e-day <end_day sun-sat> | e_mth <end_mth 1-12>
| e_time <end_time hh:mm> | offset [30 | 60 | 90 | 120]} | annual {s_date
<start_date 1-31> | s_mth <start_mth 1-12> | s_time <start_time hh:mm> |
e_date <end_date 1-31> | e_mth <end_mth 1-12> | e_time <end_time
hh:mm> | offset [30 | 60 | 90 | 120]}]
show time
show sntp
Each command is listed, in detail, in the following sections.
config sntp
Purpose Used to setup SNTP service.
Syntax
config sntp {primary <ipaddr> | secondary <ipaddr> | poll-interval <int
30-99999>}
Description Use this command to configure SNTP service from an SNTP server. SNTP
must be enabled for this command to function (See enable sntp).
Parameters
primary − This is the primary server the SNTP information will be taken from.
secondary − This is the secondary server the SNTP information will be taken
from in the event the primary server is unavailable.
poll-interval − This is the interval between requests for updated SNTP
information.
Restrictions Only administrator-level users can issue this command. SNTP service must
be enabled for this command to function (enable sntp).
<ipaddr> − The IP address of the primary server. •
•
•
<ipaddr> − The IP address for the secondary server.
<int 30-99999> − The polling interval ranges from 30 to 99,999
seconds. The default setting is 720 seconds.
Example usage:
To configure SNTP settings:
162