Specifications

DGS-3024 Layer 2 Switch CLI Reference Manual
config authen_enable
The sequence of methods implemented in this command will affect
the authentication result. For example, if a user enters a sequence of
methods like tacacs – xtacacs – local_enable, the Switch will send
an authentication request to the first tacacs host in the server group.
If no verification is found, the Switch will send an authentication
request to the second tacacs host in the server group and so on,
until the list is exhausted. At that point, the Switch will restart the
same sequence with the following protocol listed, xtacacs. If no
authentication takes place using the xtacacs list, the local_enable
password set in the Switch is used to authenticate the user.
Successful authentication using any of these methods will give the
user an “Admin” privilege.
Parameters default – The default method list for administration rights
authentication, as defined by the user. The user may choose one or
a combination of up to four (4) of the following authentication
methods:
method_list_name – Enter a previously implemented method list
name defined by the user (create authen_enable). The user may
add one, or a combination of up to four (4) of the following
authentication methods to this method list:
 tacacs – Adding this parameter will require the user to be
authenticated using the TACACS protocol from the remote
TACACS server hosts of the TACACS server group list.
 xtacacs – Adding this parameter will require the user to be
authenticated using the XTACACS protocol from the remote
XTACACS server hosts of the XTACACS server group list.
 tacacs+ – Adding this parameter will require the user to be
authenticated using the TACACS+ protocol from the remote
TACACS+ server hosts of the TACACS+ server group list.
 radius - Adding this parameter will require the user to be
authenticated using the RADIUS protocol from a remote
RADIUS server previously implemented on the Switch.
 server_group <string 15> – Adding this parameter will
require the user to be authenticated using a user-defined
server group previously configured on the Switch.
 local_enable – Adding this parameter will require the user
to be authenticated using the local user account database
on the Switch.
 none – Adding this parameter will not require authentication
to access the Switch.
 tacacs – Adding this parameter will require the user to be
authenticated using the TACACS protocol from a remote
TACACS server.
 xtacacs – Adding this parameter will require the user to be
authenticated using the XTACACS protocol from a remote
XTACACS server.
 tacacs+ – Adding this parameter will require the user to be
authenticated using the TACACS+ protocol from a remote
TACACS+ server.
 radius – Adding this parameter will require the user to be
authenticated using the RADIUS protocol from a remote
RADIUS server previously implemented on the Switch.
135