Specifications

DGS-3024 Layer 2 Switch CLI Reference Manual
show lacp_port
Purpose Used to display current LACP port mode settings.
Syntax
show lacp_port {<portlist>}
Description This command will display the LACP mode settings as they are
currently configured.
Parameters
ports <portlist> − Specifies a range of ports that will belong to the link
aggregation group. The port list is specified by listing the beginning port
number, then the highest port number of the range (separated by a
dash) are specified. Ports that are not part of the range of ports as
described above may be specified by separating the port number by a
comma. For example, ports 5 through 7 and port 9 could be specified
as part of a link aggregation group by entering ports 5-7, 9.
Restrictions Only administrator-level users can issue this command.
Example usage:
To display LACP port mode settings:
DGS-3024:4#show lacp_port 1-8
Command: show lacp_port 1-8
Port Activity
------ --------
1 Active
2 Active
3 Active
4 Active
5 Active
6 Active
7 Active
8 Active
DGS-3024:4#
106