Specifications

DGS-3024 Layer 2 Switch CLI Reference Manual
Example usage:
To display the current link aggregation configuration:
DGS-3024:4#show link_aggregation
Command: show link_aggregation
Link Aggregation Algorithm = MAC-source-dest
Group ID : 1
Master Port : 17
Member Port : 5-10, 17
Active Port:
Status : Disabled
DGS-3024:4#
config lacp_port
Purpose Used to configure settings for LACP compliant ports.
Syntax
config lacp_port <portlist> mode [active | passive]
Description This command is used to configure ports that have been previously
designated as LACP ports (see create link_aggregation).
Parameters
ports <portlist> − Specifies a range of ports that will belong to the link
aggregation group. The port list is specified by listing the beginning port
number, then the highest port number of the range (separated by a
dash) are specified. Ports that are not part of the range of ports as
described above may be specified by separating the port number by a
comma. For example, ports 5 through 7 and port 9 could be specified
as part of a link aggregation group by entering ports 5-7, 9.
mode – Select the mode to determine if LACP ports will initially send
LACP control frames.


active – Active LACP ports are capable of processing and
sending LACP control frames. This allows LACP compliant devices
to negotiate the aggregated link so the group may be changed
dynamically as needs require. In order to utilize the ability to
change an aggregated port group, that is, to add or subtract ports
from the group, at least one of the participating devices must
designate LACP ports as active. Both devices must support LACP.
passive – LACP ports that are designated as passive cannot
initially send LACP control frames, unless the port receives LACP
frames. In order to allow the linked port group to negotiate
adjustments and make changes dynamically, at one end of the
connection must have “active” LACP ports (see above).
Restrictions Only administrator-level users can issue this command.
Example usage:
To configure LACP port mode settings:
DGS-3024:4#config lacp_port 1-12 mode active
Command: config lacp_port 1-12 mode active
Success.
DGS-3024:4#
105