Specifications

DGS-3024 Layer 2 Switch CLI Reference Manual
Example usage:
To define a load-sharing group of ports, group ID 1, master port 5 of module 1 with group members ports 5-7 plus port
9:
DGS-3024:4#config link_aggregation group_id 1 master_port 5 ports 5-7, 9
Command: config link_aggregation group_id 1 master_port 5 ports 5-7, 9
Success.
DGS-3024:4#
config link_aggregation algorithm
Purpose Used to configure the link aggregation algorithm.
Syntax
config link_aggregation algorithm [mac_source |
mac_destination | mac_source_dest]
Description This command configures to part of the packet examined by the
Switch when selecting the egress port for transmitting load-sharing
data. This feature is only available using the address-based load-
sharing algorithm.
Parameters
mac_source − Indicates that the Switch should examine the MAC
source address.
mac_destination − Indicates that the Switch should examine the MAC
destination address.
mac_source_dest − Indicates that the Switch should examine the
MAC source and destination addresses.
Restrictions Only administrator-level users can issue this command.
Example usage:
To configure link aggregation algorithm for mac-source-dest:
DGS-3024:4#config link_aggregation algorithm mac_source_dest
Command: config link_aggregation algorithm mac_source_dest
Success.
DGS-3024:4#
show link_aggregation
Purpose Used to display the current link aggregation configuration on the
Switch.
Syntax
show link_aggregation {group_id <value 1-4> | algorithm}
Description This command will display the current link aggregation configuration of
the Switch.
Parameters
<value 1-4> − Specifies the group ID. The Switch allows up to 4 link
aggregation groups to be configured. The group number identifies
each of the groups.
algorithm − Specify to view the algorithm employed of this link
aggregation group.
Restrictions None.
104