User manual

4 Configuration DGS-1210 series Metro Ethernet Managed Switch User Manual

Click Apply to create a new SNMP community, Delete to remove an existing community.

System > SNMP Settings > SNMP Host Table

This page is to configure the SNMP trap recipients.

Host IP Address: Select IPv4 or IPv6 and specify the IP address of SNMP management host.

SNMP Version: Specify the SNMP version to be used to the management host.

Community String/SNMPv3 User Name: Specify the community string or SNMPv3 user name for the

management host.

Figure 4.28– System > SNMP Settings > SNMP Host Table

Click Apply to create a new SNMP host, Delete to remove an existing host.

System > SNMP Settings > SNMP Engine ID

The Engine ID is a unique identifier used to identify the SNMPv3 engine on the Switch.

Input the Engine ID then click Apply to apply the changes and click Default resets to default value.

Figure 4.29 – System > SNMP Settings > SNMP Engine ID

System > SNMP Settings > SNMP Trap Settings

The SNMP Trap Settings page provide user to Specify whether the device can send SNMP notifications.

Figure 4.30 – System > SNMP Settings > SNMP Trap Settings

SNMP Authentication Traps: Specifies the device to send authentication failure notifications.

System Device Bootup: System boot-up information.