User Manual

5 Configuration D-Link Web Smart Switch User Manual
30
System > Trap Settings (For SmartConsole)
By configuring the Trap Setting, it allows SmartConsole Utility to monitor specified events on this Web-Smart
Switch. By default, Trap Setting is disabled. When the Trap Setting is enabled, enter the Destination IP
address of the managing station that will receive trap information.
Figure 49 – System > Trap Settings
You can select which event message(s) to be sent to the managing station
System Event: The system level messages, which contains:
Device Bootup - System boot-up information.
Illegal Login - Events of incorrect password logins, recording the IP of the originating PC.
Fiber Port Link Up/Link Down: Fiber port connection information.
Twisted pair Port Link Up/Link Down: Copper port connection information.
RSTP Port State Change: Events of a RSTP port state changes.
Firmware Upgrade State: Information of firmware upgrade - success or failure.
PoE Power On/Off: Status of power per port (Only for DGS-1210-10P)
PoE Power Error: The four trap events are: power over loading, short circuit, thermal shutdown and power
deny (Only for DGS-1210-10).
NOTE: The total PoE power budget is 78 watts for
DGS-1210-10P. The remaining 7watts is reserved
for the last PoE device to be connected to the
switch. The Power Deny trap message is sent out
when the switch hits the total power budget and
when a new Power Device (PD) requests to
connect to the switch at the same time.
Over Max Power Budget: When the system supplies power to PDs and hits the max PoE power budget of
78watts, the system will send out this trap message. (Only for DGS-1210-10P)
System > Port Settings
In the Port Setting page, the status of all ports can be monitored and adjusted for optimum configuration. By
selecting a range of ports (From Port and To Port), the Speed can be set for all selected ports by clicking
Apply. Press the Refresh button to view the latest information.