User Manual

4 SmartConsole Utility D-Link Web Smart Switch User Manual
18
Web Access
Select a switch from the Device List. Click this icon to launch your Internet browser (eg. The Internet
Explorer). Here you can configure the Switch through the Web-based Management utility. You may also get
into the Web-based Management by double-clicking the device in the device list.
Add(+), Delete(-) and Discover the device
Click the Discovery button to display all of the Web-Smart devices located in the same domain with the
management PC.
Click the + and insert a device IP address to add a device into the Discover List, or select a device and click
the – button to remove it.
Figure 26 – SmartConsole Add device
Figure 27 – SmartConsole Delete device
Device List
This list displays all discovered Web-Smart devices on the network.
Figure 28 – SmartConsole Device List
Definitions of the Device List features:
Monitor: Checking the Monitor box and the SmartConsole will collect the trap and log data from the device.
The
in the monitor means the device was discovered by SmartConsole. Click the icon to have the device
to continue updating the information, such as system log or trap to the SmartConsole Utility. The icon will
appear
. When the device was detected as not reachable, the icon will change to . Please check if the
power or the cable of this device is disconnected.
IP Address: Displays the current IP addresses of devices.
MAC Address: Displays the device MAC Addresses.
Protocol version: Displays the software version of the Utility.