User manual
Table Of Contents
- D-Link DGS-1210 Series Web Smart Switch User Manual v2.01
- Table of Contents
- About This Guide
- Chapter 1 Product Introduction
- Chapter 2 Hardware Installation
- Chapter 3 Getting Started
- Chapter 4 SmartConsole Utility
- Chapter 5 Configuration
- Chapter 6 Command Line Interface
- Appendix A - Ethernet Technology
- Appendix B - Technical Specifications
- Appendix C – Rack mount Instructions
5 Configuration D-Link Web Smart Switch User Manual
SNMP Settings
The SNMP Setting allows you to quickly enable/disable the SNMP function and configure the SNMP
community name. For the complete SNMP function, please check “Setup Menu > System > SNMP Settings”
in the Web Interface. The default SNMP Setting is Disabled. Click Enabled, enter Community names, and
then click Apply to make it effective.
Read_Only Community: Read-only privilege allows authorized management stations to retrieve MIB
objects values. Default Community name is public.
Read_Write Community Read/write privilege allows authorized management stations to retrieve and modify
MIB object values. Default Community name is private.
Figure 30 – Configure SNMP in Smart Wizard
2
2
1
1