User manual
Table Of Contents
- D-Link DGS-1210 Series Web Smart Switch User Manual v2.01
- Table of Contents
- About This Guide
- Chapter 1 Product Introduction
- Chapter 2 Hardware Installation
- Chapter 3 Getting Started
- Chapter 4 SmartConsole Utility
- Chapter 5 Configuration
- Chapter 6 Command Line Interface
- Appendix A - Ethernet Technology
- Appendix B - Technical Specifications
- Appendix C – Rack mount Instructions
4 SmartConsole Utility D-Link Web Smart Switch User Manual
Device Configuration
The Device Configuration in the SmartConsole Utility has five icons:
Device Settings
Device Password Manager
Multi Firmware Upgrade
DHCP Refresh
Web Access
and the
, , device buttons for the Device List.
Device Settings
Select a switch from the Device List. Click on this icon to launch the Device Settings window. Here you can
configure the Product Name, IP Address, Gateway, Subnet Mask, System Name, Location, Trap Host IP,
Switch Group Interval, and DHCP Client Setting of the Switch.
To apply the configuration, insert the correct device password in the Confirm Password box and then click
OK
Figure 22 – SmartConsole Device Settings
16