User`s guide

D-Link DFM-562IS HSFi PCI Modem User’s Guide

WARNING

ONLY CONNECT EQUIPMENT WITH A TELECOMMUNICATIONS

MPLIA

E LABEL

WARNING

FOR SAFETY REASONS, ONLY CONNECT EQUIPMENT WITH A

TELECOMMUNICATIOS COMPLIANCE LABEL. THIS INCLUDES

CUSTOMER EQUIPMENT PREVIOUSLY LABELLED

PERMITTED OR CERTIFIED.

Modems connected to the Australian telecommunications network must be marked in

accordance with the Labeling Notice. This modem has been specifically configured to ensure

compliance with the ACA Standards. Do not adjust your modem or software outside the

values indicated as below. To do so would result in your modem being operated in a

non-compliant manner.

Modem Commands:

Command

Default Permissible Range

ATA - Do not use

ATB B0 Do not set to B1

AT&G &G0 &G2

AT&P &P0 &P1

ATSn see table below

S register

Default Permissible Range

s6 2 2 to 6

Call Attempts/Retries:

Applications software shall be configured so that no more than 3 attempts are made to

establish a connection to a given number (Note: if the modem can detect service tones, up to

10 attempts can be made). If the call sequence is unsuccessful, there shall be a delay of at

least 30 minutes before attempting to call the number again.

Failure to set the modem and any application software used with the modem, to the values

shown as above will result in the modem being operated in a non-compliant manner.

Consequently, this would be in violation of the Labeling Notice for this equipment, and the

Telecommunications ACT 1997 prescribes penalties for the connection of non-compliant

equipment.