User manual

Switch Route:
Similar as shown in the previous example. Set up the switch route with the new interface group created earlier.
Configure the rules:
1. Go to Rules > New Rule
2. The Rule Properties dialog will be displayed
3. Specify a suitable name for the rule, for instance HTTP-LAN-to-DMZ
4. Enter following:
• Action: Allow
• Source Interface: lan
• Destination Interface: dmz
• Source Network: all-nets
• Destination Network: 10.1.4.10
5. Under the Service tab, choose http in the Pre-defined control
6. Click OK
7. Go to Rules > New Rule
8. The Rule Properties dialog will be displayed
9. Specify a suitable name for the rule, for instance HTTP-WAN-to-DMZ
10. Enter following:
• Action: SAT
• Source Interface: wan
• Destination Interface: dmz
• Source Network: all-nets
• Destination Network: wan_ip
11. Under the Service tab, choose http in the Pre-defined control
12. Under the Address Translation tab, choose Destination IP Address and enter 10.1.4.10 in the New IP
Address control.
13. Click OK
14. Go to Rules > New Rule
15. The Rule Properties dialog will be displayed
16. Specify a suitable name for the rule, for instance HTTP-LAN-to-DMZ
17. Enter following:
• Action: Allow
• Source Interface: wan
• Destination Interface: dmz
• Source Network: all-nets
• Destination Network: wan_ip
18. Under the Service tab, choose http in the Pre-defined control
19. Click OK
Web Interface
Configure the interfaces:
4.6.6. Transparent Mode Scenarios Chapter 4. Routing
123