User manual

Web Interface

1. Go to Interfaces > Ethernet

2. Select the Ethernet interface of interest

3. Enable the Enable DHCP client option

4. Click OK

3.3.2.1. Useful CLI Commands for Ethernet Interfaces

This section summarizes the CLI commands most commonly used for examining and manipulating

NetDefendOS Ethernet interfaces.

Ethernet interfaces can also be examined through the Web Interface but for some operations the CLI

must be used.

To show the current interface assigned to the IP address wan_ip:

gw-world:/> show Address IP4Address InterfaceAddresses/wan_ip

Property Value

--------------------- ---------------------------

Name: wan_ip

Address: 0.0.0.0

UserAuthGroups: <empty>

NoDefinedCredentials: No

Comments: IP address of interface wan

To show the current interface assigned to the network wan_net:

gw-world:/> show Address IP4Address InterfaceAddresses/wan_net

Property Value

--------------------- ------------------------

Name: wan_net

Address: 0.0.0.0/0

UserAuthGroups: <empty>

NoDefinedCredentials: No

Comments: Network on interface wan

To show the current interface assigned to the gateway wan_gw:

gw-world:/> show Address IP4Address InterfaceAddresses/wan_gw

Property Value

--------------------- ---------------------------------

Name: wan_gw

Address: 0.0.0.0

UserAuthGroups: <empty>

NoDefinedCredentials: No

Comments: Default gateway for interface wan

By using the tab key at the end of a line, tab completion can be used to complete the command:

gw-world:/> show Address IP4Address InterfaceAddresses/wan_<tab>

[<Category>] [<Type> [<Identifier>]]:

InterfaceAddresses/wan_br InterfaceAddresses/wan_gw

InterfaceAddresses/wan_dns1 InterfaceAddresses/wan_ip

InterfaceAddresses/wan_dns2 InterfaceAddresses/wan_net

3.3.2. Ethernet Interfaces Chapter 3. Fundamentals