User's Manual

8
Click Restart
Setup Wizard Complete
Click Restart to complete your
configuration.
If you want to use the DFL-200’s built-in
DHCP Server, choose Enable DHCP
Server from this screen. You then need
to specify a range of IP addresses to
assign the DHCP clients. The range is
entered in the format “Start IP – Stop IP”
i.e. 192.168.0.100 – 192.168.0.200 or
network/subnet mask address in bits, i.e.
192.168.0.0/24. If you don’t want to use
the built-in DHCP Server or want to
configure it later, choose Disable DHCP
Server and click Next.
Using The Setup Wizard (continued)
Click Next
Step 4 - Set up built-in DHCP server
Click Next
Step 5 - Configure helper servers
NTP Servers - If enabled,
specifies which NTP Servers
should be used for time
synchronization.
Syslog Servers – If enabled,
specifies the server(s) where
system log data is sent.