User manual

58D-Link DAP-1360 User Manual
Section 3 - Conguration
Advanced
Advanced Wireless
Choose 100%, 50%(-3dB), 25% (-6dB), or
12.5% (-9dB).
This value should remain at its default setting of 2,346. If you experience a high packet error rate, you may slightly
decrease your fragmentation threshold within the value range of 256 to 2,346. Setting the fragmentation threshold too
low may result in poor performance.
Transmit Power:
Beacon Period:
Fragmentation
Threshold:
Beacons are packets sent by an access point
to synchronize a wireless network. Specify a
beacon interval value. The default value 100
is recommended.
DTIM Interval
(Beacon Rate):
Preamble Type:
A DTIM (Delivery Trafc Indication Message) is a countdown informing clients of the next window for listening to broadcast
and multicast messages. The default vaule is 3 and the possible range of vaules is between 1 and 255.
RTS Threshold:
This value should remain at its default setting of
2,432. If you encounter inconsistent data ow,
only minor modications to the value range
between 256 and 2,432 are recommended.
Select Short or Long Preamble. The default setting in Long Preamble. The Preamble denes the length of the CRC block
(Cyclic Redundancy Check is a common technique for detecting data transmission errors) for communication between
the access point and roaming wireless network adapters. Note: High network trafc areas should use the short preamble
type.
WMM:
WMM (Wi-Fi Multimedia) is only available in the Access Point and Wireless Client Mode. WMM provides basic QoS (Quality
of Service) functions for wireless networks. WMM prioritizes trafc based on 4 AC (Access Categories) : voice, video, best
effort, and background. However, WMM does not provide guaranteed throughput.The QoS (WMM) is mandatory in 11n
mode, you can disable this feature when select 11g or 11b mode.
Enable Multicast
Streams:
Use this function to enable IGMP Snooping for your wireless connection. This function will enhance your network performance
when you use multicast services such as video conferencing and video/audio streaming. This setting is enabled by default
and cannot be changed in the DAP-1360’s current mware version.