Specifications

150
config link_aggregation
Purpose
Used to configure a previously created link
aggregation group.
Syntax
config link_aggregation group_id <value>
{master_port <port>/ports <portlist>/
state [enabled/disabled]}
Description
This command allows you to configure a
link aggregation group that was created
with the create link_aggregation
command above.
Parameters
<value> − Specifies the group id. The
switch allows up to 626 link aggregation
groups to be configured. The group
number identifies each of the groups.
<port> − Master port ID. Specifies which
port (by port number) of the link
aggregation group will be the master port.
All of the ports in a link aggregation group
must be on the same module and share the
port configuration with the master port.
<portlist> − Specifies a range of ports that
will belong to the link aggregation group.
Restrictions
Only administrator-level users can issue
this command. All ports in a link
aggregation group must be on the same
module.
Example Usage:
To define a load-sharing group of ports, group-id 1,master port
1 of module 2:
DES7000:4@#config link_aggregation group_id 1 master_port 2:1
ports 2:1-1:8
Command: config link_aggregation group_id 1 master_port 2:1
ports 2:1-1:8
Success.
DES7000:4@#