User manual

Installation
Rev 1.2
Mellanox Technologies
22
Parts Included in the Installation Kit:
Figure 7: Rail and Rail Slide
15.
1. Place the ESD mat on the floor where you will be working and put on the ESD strap. Make
sure the ESD strap is touching your skin and that the other end is connected to a verified
ground.
2. Screw the rail slides to the switch. Make sure that the ears on the slide are on the connector
side of the switch. Use three flat head screws for each rail slide.
2 rails 6 recessed flat head screws
2 rail slides 8 caged nuts with pan head screws