User manual

xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch
12
Figure 2 - 5. Install DPS-200 in DPS-900
The RPS can be mounted in a standard 19" rack. Use the following diagram to guide you.
Figure 2 - 6. Install DPS-900 in equipment rack
CAUTION: Installing systems in a rack without the front and side stabilizers installed
could cause the rack to tip over, potentially resulting in bodily injury under certain
circumstances. Therefore, always install the stabilizers before installing components in
the rack. After installing components in a rack, do not pull more than one component
out of the rack on its slide assemblies at one time. The weight of more than one
extended component could cause the rack to tip over and may result in injury.
DPS-800
The DPS-800 is a standard-size rack mount (1 standard unit in height) designed to hold up to 2 DPS-
200 redundant power supplies.