User manual

xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch
108
RIP routing protocol. The user may specify a cost between 0 and 16.
Click Add/Modify to implement changes made.
NOTE: The source protocol (Src. Protocol) entry and the
destination protocol (Dst. Protocol) entry cannot be the
same.
Static/Default Route Settings
Entries into the Switch’s forwarding table can be made using both MAC addresses and IP addresses.
Static IP forwarding is accomplished by the entry of an IP address into the Switch’s Static IP Routing
Table. To view the following window, click Layer 3 Features > Static/Default Route Settings.
Figure 8- 6. Static/Default Route Settings window
This window shows the following values:
Parameter Description
IP Address
The IP address of the Static/Default Route.
Subnet Mask
The corresponding Subnet Mask of the IP address entered into the table.
Gateway
The corresponding Gateway of the IP address entered into the table.
Metric
Represents the metric value of the IP interface entered into the table. This field may
read a number between 1-65535 for an OSPF setting, and 1-16 for a RIP setting.
Protocol
Represents the protocol used for the Routing Table entry of the IP interface. This field
may read OSPF, RIP, Static or Local.
Backup State
Represents the Backup state that this IP interface is configured for. This field may read
Primary or Backup.
Delete
Click the
if you would like to delete this entry from the Static/Default Route
Settings table.
To enter an IP Interface into the Switch’s Static/Default Route Settings window, click the Add
button, revealing the following window to configure.