User manual

xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch
107
Internal
External
ExtType1
ExtType2
Inter-E1 Inter-E2
RIP 0 to 16777214 Type 1 Type 2
Static 0 to 16777214 Type 1 Type 2
Local 0 to 16777214 Type 1 Type 2
Table 8- 3. Route Redistribution Source table
Entering the Type combination − internal type_1 type_2 is functionally equivalent to all. Entering the
combination type_1 type_2 is functionally equivalent to external. Entering the combination internal
external is functionally equivalent to all.
Entering the metric 0 specifies transparency.
This window will redistribute routing information between the OSPF and RIP routing protocols to all
routers on the network that are running OSPF or RIP. To access the Route Redistribution Settings
window, go to > Layer 3 Features > Route Redistribution Settings:
Figure 8- 5. Route Redistribution Settings and Table window
The following parameters may be set or viewed:
Parameter Description
Dst. Protocol
Allows for the selection of the protocol for the destination device. Choose between RIP
and OSPF.
Src. Protocol
Allows for the selection of the protocol for the source device. Choose between RIP,
OSPF, Static and Local.
Type
Allows for the selection of one of six methods of calculating the metric value. The user
may choose between All, Internal, External, ExtType1, ExtType2, Inter-E1, Inter-E2.
See the table above for available metric value types for each source protocol.
Metric
Allows the entry of an OSPF interface cost. This is analogous to a Hop Count in the
RIP r
outing protocol The user may specify a cost between 0 and 16