Specifications

Access Control

LNL-1320 Series 2

Lenel Systems International offers a Dual Reader Interface (DRI) module for access control

solutions. Most access control card readers, keypads, or readers with keypads that use standard

Wiegand Data1/Data0 or Clock/Data communication are supported, as are those that support the

bidirectional RS-485 Open Supervised Device Protocol (OSDP). Lock, unlock, and facility code

offline access modes are supported on all readers connected to the DRI. Each DRI supports up to

eight different card formats as well as issue codes for both magnetic and Wiegand card formats.

The DRI provides a vital link between the Intelligent System Controller (ISC) and the card reader

attached to the interface. As many as 32 DRI modules can be multidropped using RS-485 2-wire

or 4-wire communication up to 4,000 feet per port away from the ISC. Each DRI module is

individually addressed for increased reporting capabilities with OnGuard access control software

applications. The DRI includes eight inputs that support normally open, normally closed,

supervised, and non-supervised circuits. In addition, six output relays support fail-safe or

fail-secure operation.

Features and Functionality

■ 12 or 24 VDC power supply

■ Supports Data1/Data0, Clock/Data and Lenel OSDP-compatible RS-485 readers and keypads

■ Downloadable firmware

■ Six Form-C 5 A at 30 VDC relay outputs

■ Up to 16 different formats (8 card formats and 8 asset formats)

■ Issue code support for magnetic and Wiegand formats

■ Door contact supervision (open/closed)

■ REX push-button monitor

■ Strike control output

■ Bicolor reader status LED support and 2-wire LED support

■ Beeper control

■ Dedicated tamper and power failure circuits

■ Support for offline reader access mode

■ On-board jumpers for termination

■ On-board regulator allows 12 VDC reader support from 24 VDC power source

■ DIP switch-selectable addressing

Dual Reader Interface Module