User manual

4 Configuration DES-1210 Metro Ethernet Managed Switch User Manual
30
Figure 4.41 - System > System Log Configuration > System Log Server
Server ID: Specifies the Server ID. The field range is 1-4.
Severity: Specifies the minimum severity from which warning messages are sent to the server. There are
three levels. When a severity level is selected, all severity level choices above the selection are selected
automatically. The possible levels are:
Warning - The lowest level of a device warning. The device is functioning, but an operational
problem has occurred.
Informational - Provides device information.
All - Displays all levels of system logs.
Server IPv4 Address: Specifies the IPv4 address of the system log server.
Server IPv6 Address: Specifies the IPv6 address of the system log server.
Facility: Specifies an application from which system logs are sent to the remote server. Only one facility can
be assigned to a single server. If a second facility level is assigned, the first facility is overwritten. There are
up to eight facilities can be assigned (Local 0 ~ Local 7).
UDP Port: Specifies the UDP port to which the server logs are sent. The possible range is 6000 – 65535,
and the default value is 514.
Status: Specifies the status is enable or disable.
System > SMTP Service > SMTP Server Settings
The SMTP Service Settings page is used to configure the fields to set up the SMTP server for the switch,
along with setting e-mail addresses to which switch log file can be sent when a problem arises on the Switch.
User can Enabled or Disabled the SMTP State, then input the SMTP Server Address, SMTP Server Port,
Self Mail Address and Mail Receiver Address then click Apply button to configure.
Figure 4.42 - System > SMTP Service > SMTP Server Settings
SMTP State: Enabled or Disabled the SMTP service on this device.
SMTP Server Address: Select IPv4 or IPv6 and enter the IP address of the SMTP server on a remote
device. This will be the device that sends out the mail for user.
SMTP Server Port: Enter the virtual port number that the Switch will connect with on the SMTP server. The
common port number for SMTP is 25, yet a value between 1 and 65535 can be chosen.
Self Mail Address: Enter the e-mail address from which mail messages will be sent. This address will be the
“from” address on the e-mail message sent to a recipient. Only one self mail address can be configured for
this Switch. This string can be no more that 64 alphanumeric characters.
Mail Receiver Address: Enter a list of e-mail addresses so recipients can receive e-mail messages
regarding Switch functions. Up to 8 e-mail addresses can be added per Switch. Do delete these addresses
from the Switch, click Delete button from the Mail Receiver Address Table.