User`s guide

D-Link DGS-3324SR Layer 3 Stackable Gigabit Ethernet Switch

Figure 4- 42. Access Rule Configuration window (IP)

Configure the following Access Rule Configuration settings:

Parameter Description

Profile ID

This is the identifier number for this profile set.

Mode

Select Permit to specify that the packets that match the access profile are

forwarded by the Switch, according to any additional rule added (see

below).

Select Deny to specify that packets that do not match the access profile

are not forwarded by the Switch and will be filtered.

Access ID

Type in a unique identifier number for this access. This value can be set

from 1 – 50.

Type

Selected profile based on Ethernet (MAC Address) or IP address. Ethernet

instructs the Switch to examine the layer 2 part of each packet header. IP

instructs the Switch to examine the IP address in each frame’s header.

Priority (0-7)

Select this option to instruct the Switch to use the 802.1p priority value

entered in the adjacent field for packets that meet the criteria. A number

between 0 − lowest priority, and 7 − highest priority, can be entered.

Replace Dscp (0-63)

Select this option to instruct the Switch to replace the DSCP value (in a

packet that meets the selected criteria) with the value entered in the

adjacent field.

Vlan Name

Allows the entry of a name for a previously configured VLAN.

Source IP

Source IP Address - Enter an IP Address mask for the source IP address.