User`s guide

D-Link DGS-3324SR Layer 3 Stackable Gigabit Ethernet Switch

dest port mask − Specify a TCP port mask for the destination port in hex

form (hex 0x0-0xffff).

protocol id − Specify a Layer 4 port mask for the destination port in hex

form (hex 0x0-0xffffffff).

Port

The user may set the Access Profile Table on a per-port basis by

entering an entry in this field. The user may select all, denoting all ports

within the switch stack, or enter a port or ports. The port list is specified by

listing the lowest switch number and the beginning port number on that

switch, separated by a colon. Then the highest switch number, and the

highest port number of the range (also separated by a colon) are specified.

The beginning and end of the port list range are separated by a dash. For

example, 1:3 specifies switch number 1, port 3. 2:4 specifies switch

number 2, port 4. 1:3-2:4 specifies all of the ports between switch 1, port 3

and switch 2, port 4 − in numerical order.

To establish the rule for a previously created Access Profile:

In the Configuration folder, click the Access Profile Table link opening the Access Profile Table. Under the

heading Access Rule, clicking Modify, will open the following window.

Figure 4- 41. Access Rule Table window

To create a new rule set for the access profile click the Add button. A new window is displayed. To remove a

previously created rule, select it and click the

button.