User`s guide

D-Link DGS-3324SR Layer 3 Stackable Gigabit Ethernet Switch
71
Destination Mac
Destination MAC Mask - Enter a MAC address mask for the destination
MAC address.
802.1p
Selecting this option instructs the Switch to examine the 802.1p priority
value of each packet header and use this as the, or part of the criterion for
forwarding.
Ethernet type
Selecting this option instructs the Switch to examine the Ethernet type
value in each frame’s header.
Port
The user may set the Access Profile Table on a per-port basis by
entering an entry in this field. The user may select all, denoting all ports
within the switch stack, or enter a port or ports. The port list is specified by
listing the lowest switch number and the beginning port number on that
switch, separated by a colon. Then the highest switch number, and the
highest port number of the range (also separated by a colon) are specified.
The beginning and end of the port list range are separated by a dash. For
example, 1:3 specifies switch number 1, port 3. 2:4 specifies switch
number 2, port 4. 1:3-2:4 specifies all of the ports between switch 1, port 3
and switch 2, port 4 − in numerical order.
The page shown below is the IP Access Profile Configuration page.
Figure 4- 40. Access Profile Configuration (IP)
The following parameters can be set, for IP: