User`s guide

D-Link DGS-3324SR Layer 3 Stackable Gigabit Ethernet Switch
70
Figure 4- 38. Access Profile Table
To add an entry to the Access Profile Table, click the Add button. This will open the Access Profile
Configuration page, as shown below. There are two Access Profile Configuration pages − one for Ethernet
(or MAC address-based) profile configuration, and one for IP address-based profile configuration. You can
switch between the two Access Profile Configuration pages by using the Type drop-down menu, and clicking
on the Apply button. The page shown below is the Ethernet Access Profile Configuration page.
Figure 4- 39. Access Profile Table (Ethernet)
The following parameters can be set, for Ethernet:
Parameter Description
Profile ID (1-8)
Type in a unique identifier number for this profile set. This value can be set
from 1 – 8.
Type
Select profile based on Ethernet (MAC Address) or IP address. This will
change the menu according to the requirements for the type of profile.
Select Ethernet to instruct the Switch to examine the layer 2 part of each
packet header. Select IP to instruct the Switch to examine the IP address
in each frame’s header.
Vlan
Selecting this option instructs the Switch to examine the VLAN part of each
packet header and use this as the full or partial criterion for forwarding.
Source Mac
Source MAC Mask - Enter a MAC address mask for the source MAC
address.