User`s guide

D-Link DGS-3324SR Layer 3 Stackable Gigabit Ethernet Switch
27
Multicast Router
Only
If this option is enabled and IGMP Snooping is also enabled, the Switch
forwards all multicast traffic to a multicast-enabled router only. Otherwise,
the Switch will forward all multicast traffic to any IP router.
GVRP Status
Use this pull-down menu to Enable or Disable GVRP on the Switch.
Telnet Status
Telnet configuration is Enabled by default. If you do not want to allow
configuration of the system through Telnet choose Disabled.
Web Status
Web-based management is Enabled by default. If you choose to disable
this by selecting Disabled, you will lose the ability to configure the system
through the web interface as soon as these settings are applied.
RMON Status
Remote monitoring (RMON) of the Switch is Enabled or Disabled here.
Link Aggregation
Algorithm
The algorithm that the Switch uses to balance the load across the ports
that make up the port trunk group is defined by this definition. Choose
MAC Source, MAC Destination, MAC Src & Dest, IP Source, IP
Destination or IP Src & Dest (See the Link Aggregation section of this
manual).
Switch 802.1x
Enables or disables 802.1x; default is Disabled.
Auth Protocol
The user may choose between Local and Radius Eap.
HOL Prevention
Enables or disables HOL (Head of Line) prevention; default is Enabled.
Jumbo Frame
Enables or disables Jumbo Frame acceptance; default is Disabled.
Syslog State
Enables or disables Syslog State; default is Disabled.