User`s guide

D-Link DGS-3324SR Layer 3 Stackable Gigabit Ethernet Switch
136
SNMP Community Table Configuration
Use this table to create an SNMP community string to define the relationship between the SNMP manager and
an agent. The community string acts like a password to permit access to the agent on the Switch. One or more of
the following characteristics can be associated with the community string:
An Access List of IP addresses of SNMP managers that are permitted to use the community string to gain access
to the Switch’s SNMP agent.
Any MIB view that defines the subset of all MIB objects will be accessible to the SNMP community.
Read/write or read-only level permission for the MIB objects accessible to the SNMP community.
To configure SNMP Community entries, open the SNMP Manager folder and click the SNMP Community
Table link, which will open the following screen:
Figure 5- 9. SNMP Community Table Configuration and Table
The following parameters can set:
Parameter Description
Community Name
Type an alphanumeric string of up to 33 characters that is used to identify
members of an SNMP community. This string is used like a password to
give remote SNMP managers access to MIB objects in the switch’s
SNMP agent.
View Name
Type an alphanumeric string of up to 32 characters that is used to identify
the group of MIB objects that a remote SNMP manager is allowed to
access on the switch. The view name must exist in the SNMP View Table.
Access Right
read_only − Specifies that SNMP community members using the
community string created with this command can only read the contents
of the MIBs on the switch.
read_write − Specifies that SNMP community members using the
community string created with this command can read from and write to
the contents of the MIBs on the switch.
To implement the new settings, click Apply. To delete an entry from the SNMP Community Table, click the
under the Delete heading, corresponding to the entry you wish to delete.