User`s guide

D-Link DGS-3324SR Layer 3 Stackable Gigabit Ethernet Switch
131
Figure 5- 2. SNMP User Table Display
The following parameters are displayed:
Parameter Description
User Name
An alphanumeric string of up to 32 characters. This is used to identify the
SNMP users.
Group Name
This name is used to specify the SNMP group created can request SNMP
messages.
SNMP Version
V1 – Indicates that SNMP version 1 will be used.
V2 – Indicates that SNMP version 2 will be used.
V3 – Indicates that SNMP version 3 will be used.
Auth-Protocol
None − Indicates that no authorization protocol is in use.
MD5 − Indicates that the HMAC-MD5-96 authentication level will be used.
SHA − Indicates that the HMAC-SHA authentication protocol will be used
.
Priv-Protocol
None − Indicates that no authorization protocol is in use.
DES − Indicates that DES 56-bit encryption is in use based on the CBC-
DES (DES-56) standard.
To return to the SNMP User Table, click the Show All SNMP User Table Entries link.
To add a new entry to the SNMP User Table Configuration, click on the Add button on the SNMP User Table
page. This will open the SNMP User Table Configuration page, as shown below.