User`s guide

D-Link DGS-3324SR Layer 3 Stackable Gigabit Ethernet Switch
97
RIP version 2 also adds a 16-bit route tag that is retained and sent with router updates. It can be used to identify
the origin of the route.
Because the version number in RIP2 occupies the same octet as in RIP1, both versions of the protocols can be
used on a given router simultaneously without interference.
Setting Up RIP
To setup RIP for the IP interfaces configured on the Switch, the user must enable RIP and then configure RIP
settings for the individual IP interfaces. To globally enable RIP on the Switch, open the Configuration folder to
Layer 3 Networking and then open the RIP folder and click on the RIP Configuration link to access the
following screen:
Figure 4- 66. RIP Global Setting window
To enable RIP, simply use the pull down menu, select Enabled and click Apply.
RIP Interface Settings
RIP settings are configured for each IP interface on the Switch. Click the RIP Interface Settings link in the RIP
folder. The menu appears in table form listing settings for IP interfaces currently on the Switch. To configure
RIP settings for an individual interface, click on the hyperlinked Interface Name. Click the Next button to view
the next screen of configured RIP Interface Settings.
Figure 4- 67. RIP Interface Settings window