User`s guide

D-Link DGS-3324SR Layer 3 Stackable Gigabit Ethernet Switch
92
Type
Allows for the selection of one of six methods of calculating the metric value.
The user may choose between All, Internal, External, ExtType1, ExtType2,
Inter-E1, Inter-E2. See the table above for available metric value types for
each source protocol.
Metric
Allows the entry of an OSPF interface cost. This is analogous to a Hop
Count in the RIP routing protocol.
Click Apply to enter the new settings. To delete an entry, click the corresponding under the Delete heading.
NOTE: The source protocol (Src Protocol) entry and the destination
protocol (Dest Protocol) entry cannot be the same.
Static/Default Route
Entries into the Switch’s forwarding table can be made using both MAC addresses and IP addresses. Static IP
forwarding is accomplished by the entry of an IP address into the Switch’s Static IP Routing Table.
Figure 4- 62. Static/Default Routes Settings window
This window shows the following values:
Parameter Description
IP Address
The IP address of the Static/Default Route.
Subnet Mask
The corresponding Subnet Mask of the IP address entered into the table.
Gateway
The corresponding Gateway of the IP address entered into the table.
Hops
Represents the metric value of the IP interface entered into the table. This
field may read a number between 1-65535 for an OSPF setting, and 1-16 for
a RIP setting.
Protocol
Represents the protocol used for the Routing Table entry of the IP interface.
This field may read OSPF, RIP, Static or Local.
Backup State
Represents the Backup state that this IP interface is configured for. This
field may read Primary or Backup.
Delete
Click the
if you would like to delete this entry from the Static/Default
Route Settings table.