User`s guide

D-Link DGS-3324SR Layer 3 Stackable Gigabit Ethernet Switch
91
Route Source Metric Type
OSPF 0 to 16 All
Internal
External
ExtType1
ExtType2
Inter-E1
Inter-E2
RIP 0 to 16777214 Type 1
Type 2
Static 0 to 16777214 Type 1
Type 2
Local 0 to 16777214 Type 1
Type 2
Table 4- 6. Route Redistribution Source table
Entering the Type combination − internal type_1 type_2 is functionally equivalent to all. Entering the
combination type_1 type_2 is functionally equivalent to external. Entering the combination internal external is
functionally equivalent to all.
Entering the metric 0 specifies transparency.
This window will redistribute routing information between the OSPF and RIP routing protocols to all routers on
the network that are running OSPF or RIP. To access the Route Redistribution Table Configuration window,
go to Configuration > Layer 3 IP Networking > Route Redistribution Settings:
Figure 4- 61. Route Redistribution Table Configuration window
The following parameters may be set or viewed:
Parameter Description
Dest Protocol
Allows for the selection of the protocol for the destination device. Choose
between RIP and OSPF.
Src Protocol
Allows for the selection of the protocol for the source device. Choose
between RIP, OSPF, Static and Local.