User`s guide

D-Link DGS-3324SR Layer 3 Stackable Gigabit Ethernet Switch
89
Go to the Configuration folder, and click on the Layer 3 IP Networking folder, and then click on the Setup IP
Interfaces link to open the following dialog box:
Figure 4- 58. IP Interface Table window
To setup a new IP interface, click the Add button. To edit an existing IP Interface entry, click on an entry under
the Interface Name heading. Both actions will result in the same screen, as shown below.
Figure 4- 59. IP Interface Configuration window
Choose a name for the interface to be added and enter it in the Interface Name field (if you are editing an IP
Interface, the Interface Name will already be in the top field as seen in the window above). Enter the interface’s
IP address and subnet mask in the corresponding fields. Pull the Active pull-down menu to Yes and click Apply
to enter to make the IP interface effective. Use the Save Changes dialog box from the Basic Setup folder to
enter the changes into NV-RAM. To view entries in the IP Interface Table, click the Show All IP Interface
Entries hyperlink.
The following fields can be set:
Parameter Description
Interface Name
This field displays the name for the IP interface. The default IP interface is
named “System”.
IP Address
This field allows the entry of an IP address to be assigned to this IP
interface.
Subnet Mask
This field allows the entry of a subnet mask to be applied to this IP interface.
VLAN Name
This field allows the entry of the VLAN Name for the VLAN the IP interface
belongs to.
State <Disabled>
This field may be altered between Enabled and Disabled using the pull
down menu. This entry determines whether the interface will be active or
not.