User's Manual
25D-Link DCS-5222L/DCS-5211L User Manual
Section 4 - Configuration
This section allows you to congure your LAN and Internet conguration.
Automatic IP Address Select: This option is used if you are running a DHCP
server on your network and would like an IP address assigned to your camera
automatically by the DHCP server. If the DHCP server does not exist the IP camera
will run with an auto address of 169.254.xxx.xxx, you may need to manually
congure this setting should no DHCP server exist.
Static IP Address: This option is used to congure your IP Camera with an IP
address which matches your network settings.
HTTP Port: This option allocates the HTTP port of the camera, allowing you to
connect via a standard web browser, in this example picture (right) the port is
set to 1111. The address used in a web browser could be (depending on the IP
settings used in your network)192.168.0.20:1111.
RTSP Port: This option allocates the RTSP port of the camera, the RSTP port
allows connections using QuickTime or other streaming mobile devices.
UPnP Enable: UPnP (Universal Plug & Play) can be used to allow discovery of a
camera as a UPnP device in the network, without additional conguration.
UPnP Port Forward: If the router being used supports UPnP, your camera and
router can communicate allowing the router to discover which ports are used
by each camera.
Bonjour: Enabling Bonjour will allow discovery of cameras by Apple computers.
Note: If you need to use a static IP address and you do not know the network information, contact your Internet Service
Provider (ISP) for assistance.
Network Setup