User's Manual
16D-Link DCS-935L User Manual
Section 2 - Installation
Mounting the Camera
To mount your camera on a wall or ceiling, please follow the steps below. It is recommended that you congure the camera
before mounting.
Depending on the material of the wall or ceiling, use proper tools to drill two holes 25mm
deep, 40mm apart with a 6mm drill bit where you marked. Insert the screws into the holes. If
the wall is made out of concrete, drill the holes rst, then insert the plastic anchors to support
the screws.
Place the mounting base over the screws that are mounted on the wall. Make sure to t the
screw-heads over the big holes and slide it downward to lock rmly. Lightly pull the base
forward to make sure that it is locked. Adjust the angle of the camera as desired.