User Manual
13D-Link DCS-6315 User Manual
Section 2: Assembly and Installation
Step 1
Place the Alignment Sticker in the intended location for your
camera, making sure you allow sucient space for both
the DCS-6315 and the wire-in bracket. You can refer to the
diagrams for "Dimensions" on page 71.
Step 2
Use a 6mm drill bit to make required holes approximately
30mm deep.
Step 3
Remove the Alignment Sticker.
Step 4
Insert wall anchors and attach the mounting plate, using the
screws provided.
Deploying the Camera
Note: Before deploying the camera to a xed location, you should take a photo from the intended location to make sure the camera
will have an adequate eld-of-view.