User manual

20D-Link DCS-6112 /6113 User Manual
Installation
Adjust the viewing angle
Loosen the pan screw and turn the lens module left and right until the desired position is achieved; tighten the pan screw once
completed. Loosen the tilt screws on both sides of the camera, and turn the lens module up and down until the desired position is
achieved; tighten the tilt screws once completed.
Loosen the image adjustment screw and turn the lens to adjust the network camera’s image until the desired orientation is achieved,
tighten the image adjustment screw once completed.
Attaching the Enclosure
1.Align the inner side of the black cover with the notch on both
sides of the lens, x the black Cover.
2.If you choose to the feed the cable through the ceiling or wall,
arrange the cable neatly through the cable hole. If you choose to
feed the cable from the side, remove plate A.
3.Attach the dome cover to the camera as the direction shown
below. With idiot-proof mechanism design, the dome cover
cannot be attached if the angle does not t.
4.Finally, make sure all parts of the camera are securely installed.
Loosen
Tighten
Tilt 85°
Pan 350°
Rotate 350°