Install guide

D-Link DCS-6112/DCS-6113 Quick Install Guide
10
5. Adjust the viewing angle
Loosen the pan screw and turn the lens module left and right until the desired position is
achieved. Tighten the pan screw once completed. Loosen the tilt screws on both sides of the
camera and then turn the lens module up and down until the desired position is achieved.
Tighten the tilt screws once completed.
Loosen the image adjustment screw and turn the lens to adjust the network camera’s image
until the desired orientation is achieved. Tighten the image adjustment screw once completed.
6. Attaching the Enclosure
1. Align the inner-side of the black cover with the notch on both sides of the lens.
2. If you choose to feed the cable through the ceiling or wall, arrange the cable neatly through
the cable hole. If you choose to feed the cable from the side, remove plate A.
3. Attach the dome cover to the camera as shown below. The dome cover cannot be attached
if the angle does not t.
4. Finally, make sure all parts of the camera are installed securely.
Loosen
Tighten
Tilt 85°
Pan 350°
Rotate
350°
A