User manual

Appendix B - Reset and Restore
79D-Link DCS-6110 User Manual
Reset and Restore
RESET: 1.
2.
3.
RESTORE: 1.
2.
3.
Restoring the factory defaults will result in the
loss of any previous settings and will require
running the Installation Wizard to return the
DCS-6110 to a normal state.
The LED on the front of the camera will begin blinking red and
green.
Lightly insert a paper clip (or a similar sized tool) into the reset
hole on the back of the camera, press lightly and then release
the button.
Insert the paperclip or other tool and press on the button
continuously.
Wait for the LED on the front of the camera to blink red and
green and hold the button for 30 seconds.
Withdraw the tool after the second cycle of the LED blinking
and a factory restore has been completed.
When the LED stops the blinking the reset has completed.
Reset button
There is a button hidden in the pinhole beside the Ethernet socket. It is used to reset the system or restore the factory default settings.
Sometimes resetting the DCS-6110 will return the system back to a normal state. If the system still has problems after reset, restore
the factory settings and install again: