User manual

24D-Link DCS-6110 User Manual

Section 3 - Conﬁguration

Attaching the Enclosure

Once the lens is properly adjusted, rearrange the light shield so that it will not obstruct the lens during surveillance.

Place the dome enclosure over the network camera so that the LED sticker on the dome

enclosure is properly aligned with the camera’s LED. Insert the supplied screws into the

two holes located at the base of the dome enclosure, tighten until secure.

Place the ring enclosure over the dome enclosure. Once placed, gently turn the ring

enclosure clockwise until it locks and is securely attached to the dome enclosure.

Note: When attaching the ring enclosure, be sure to ﬁrst align the line on the ring enclosure with the

triangle on the dome enclosure. When attachment is successful, the line on the ring enclosure will be

aligned with the line on the dome enclosure.