User`s manual

37
V1.10
8.9. Alarm Action
8.9.1. To Activate Alarm Action – Image, Sensor
【Step1.】 Start Alarm Action
Select the Image icon and click the Alarm button in Manu Bar
to bring up the window.
【Step2.】 Select “Alarm Activation”
Click to select whether you want to trigger alarm in “Disable”,
“Always”, or “Schedule” status. It is disabled by default. You
can change to “Always” to turn it on, or “Schedule” to activate
based on the schedule setting.
【Step3.】 The “Holiday” Option
Check this option to allow the program records on holiday based on the holiday setup. (Please refer to C4.2)
【Step4.】 The “Alarm Interval”
Configure the number of seconds between alarms. If successive alarm occurred during this interval, it will be ignored. The total seconds of
pre-alarm and post-alarm are suggested to be the minimum of alarm interval. Alarm Interval is camera dependent, DCS-900 series has 120
sec as the minimum alarm interval, and the others are 30 sec of the minimum interval
【Step5.】 Click Add to add new Alarm Action.
Click OK to save all alarm action configuration. (including Add…, Modify…, Remove and Copy…) To dismiss this window, click Cancel to
ignore all configuration.
【 Note】 Alarm Action can be added by copying from other device you have configured previously. Just click Copy and
select the device whose alarm actions you want to copy, and click OK to update the action table.
.