User manual
18D-Link DCS-5020L User Manual
Section 2 - Installation
Mounting the Camera
To mount your camera on a wall or ceiling, please follow the steps below.
It is suggested that you congure the camera before mounting.
Use appropriate tools to drill two holes the same diameter as the
plastic anchors. After drilling the holes, insert the plastic anchors to
support the screws.
If desired, the power and Ethernet cables can be concealed behind the
mounting bracket. Run the cables through the back of the mounting
bracket, securing them with the built-in guides. Be sure to leave enough
cable length protruding from the top to allow connection to the camera.
Place the mounting bracket where you want to position the
camera and use a pencil to mark the holes.
Do not overtighten the screws as this may crack the mounting bracket.
Fasten the mounting bracket to the wall using the screws provided.
2
3
4
1