User manual
7D-Link DCS-3411/3430 User Manual
Section 1 - Product Overview
Hardware Overview
Link LED
Once a connection has been established via
Ethernet port, the LINK LED will turn solid green.
If trac is passing to the camera the LINK LED
will blink. If no Ethernet connection is detected
the LINK LED will not light up.
I/O Connector
The DCS-3411/3430 provides a terminal block with
three pairs of connectors situated on the back panel.
Two pairs are for input and the other is for output. The
I/O connectors provide the physical interface to send
and receive digital signals to and from a variety of
external devices.
Power LED
The power LED is on the back of the
camera. As soon as the power adapter
is connected to the camera, the LED
will turn red. Once a connection has
been established via Ethernet port, the
LINK LED will turn solid green. If trac
is passing to the camera the LINK LED
will blink. If no Ethernet connection is
detected the LINK LED will not light up.
DC Power Connector
The DC power input connector is
located on the DCS-3411/3430 Network
Camera’s back panel and is labeled
12V DC with a single socket to supply
power to the Network Camera.
Antenna Connectors (DCS-3430)
Connects to the wireless antennas.