User manual
36D-Link DCS-3411/3430 User Manual
Section 3 - Configuration
Wireless Setup
This sections allows you to setup and congure the wireless settings for your camera.
Enable Wireless:
Site Survey:
SSID:
Wireless Mode:
Channel:
Authentication:
Encryption:
Key:
Signal:
Select to enable wireless conguration.
Select the wireless connection you would like to
use from the pull-down menu.
Enter the name of you wireless network.
Use the dropdown box to select the mode of
the wireless network you wish to connect to.
Infrastructure is normally used to connect to
an access point or router. Ad-Hoc is usually
used to connect directly to another computer.
If you are using Ad Hoc mode, select the
channel of the wireless network you wish to
connect to, or select Auto.
Select the authentication you use on your
wireless network - Open, Shared (WEP),
WPA-PSK, or WPA-PSK2.
If you use WPA-PSK or WPA-PSK2 authentication, you will need to specify whether your wireless network uses TKIP or
AES encryption. If you use Open or Shared authentication, this setting will be automatically set for you.
If you use WEP, WPA-PSK, or WPA-PSK2 authentication, enter the Key (also known as password) used for your wireless
network.
Indicates the strength of the wirelss signal between the camera and the access point.