User manual
51D-Link DCS-3010 User Manual
Conguration
Motion can be detected by measuring change in speed or vector of an object or
objects in the eld of view.
Enable Motion Detection: Select this option to turn on the motion detection
feature.
Window Name: Create your own name for the monitored area/ window. It will
show at the top of the motion window.
Sensitivity: Set the measurable difference between two sequential images that
would indicate motion.
Percentage: Set the amount of motion in the window being monitored that is
required to trigger a motion detected alert. If this is set to 100%, this means that
motion must be detected within the whole window to trigger a snapshot.
Note: Setting a higher sensitivity and a lower percentage will make motion easier
to be detected.
New: Click to add a new window. A maximum of three motion windows can be
opened simultaneously. Use your mouse to drag the window frame to resize or
the title bar to move. Clicking on the ‘x’ at the upper right corner of the window will
close the window.
Save: Save the congured settings.
To enable motion detection, follow the steps below:
1. Click New to add a new motion detection window.
2. Enter a name in the Window Name eld.
3. Dene the sensitivity to moving objects and the space ratio of all alerted pixels
by moving the Sensitivity and Percentage slide bar.
4. Click Save to apply the changes.
5. Select Enable motion detection to activate motion detection.
Motion Detection
Event Management
Prole:
You can congure two sets of sensor setting:
one for normal situations(Prole1), the other for
special situations(Prole2), such as day/night/
schedule mode.