Installation Guide

Step 1:

Place the mount at the desired location, assuring

that it is at least 20 cm from the ceiling. Use a pencil

to mark the holes.

Step 2:

Using a 6 mm drill bit, drill two 25 mm deep holes

over the pencil marks. For a plaster, drywall, or

concrete wall, insert the plastic anchors to support

the screws rst.

Step 3:

Place the mount over the holes that are in the wall.

Make sure to align the mount holes with the holes

in the wall. Use the supplied screws to attach the

mount to the surface of the wall.

Step 4:

Rotate the wing nut counterclockwise with your

ngers to slightly loosen it. Then move the bracket

to the approximate desired position.

Step 5:

Screw the camera onto the mounting screw by

tightening the plastic nger nut.

Camera Mounting Instructions

Threaded Mount

Step 6:

Adjust the angle of the arm on the mounting bracket

as required. Tighten the wing nut to lock the

camera's position into place.